Monday, August 14, 2017

DIY Cabinet Door Spice Rack



This rack is spicy!

Ok, that may have been a little cheesy but that is sort of my thing.  Those that have been around my YouTube channel for a while have come to expect that kind of humor.

I don't know about where you keep your spices but ours have always been in one of our kitchen cabinets.  It always takes up at least one of them.  It was like that when I was a kid and I've never thought about changing it much.




That is until now.

Introducing the handy dandy super duper organizing DIY project for all your spicy spices.  Plus some that are not so hot.  Hehe!!

DIY Inside Cabinet Door Spice Rack




Materials


2 - 1x4s (1/2" Thickness)

2 One Quarter Inch Diameter Dowels - These are usually sold in 36" lengths.  Some may be 24" and in that case you would need 4.

NOTE: All board lengths are 8' long and 3/4" thick unless otherwise noted.

Choice of Stain




Cut List

1 Top @ 2.75" x 13.5"

1 Bottom @ 2.75" x 13.5"

2 Sides @ 2.75" x 25.75"

3 Shelves @ 2.25" x 13"

3 Quarter Inch Dowels @ 13"

Cutting Diagrams


1x4s
 


Step 1

Cut the side pieces to length.  Then route 3 dadoes the thickness of the shelves in each side.  I have them placed 6" apart for this project listing however, you could space them as far apart as you choose.

You could also add shelves or take them away.  It's up to you.  Make it yours.

Don't forget to drill the holes for the dowels.  I have the lengths listed for a quarter inch deep seat.

However, you could drill all the way through the sides to make them through dowels.  This would add a bit of visual appeal to the project in my opinion.

The dowels are measured one inch up from the top of their corresponding shelf and 1/4" in from the front.





Step 2

A dab of wood glue in each dowel hole.  Then seat each of the dowels firmly.



Step 3

Each of the shelves for the spice rack can be glued in place and before the glue has a chance to set proceed to step 4.



Step 4

Position the other side of the spice rack seating the corresponding dowels and shelves.  Continue on before the glue sets.



Step 5

Glue the top and bottom pieces in place.  At this point a few right angle clamps can be used to ensure the whole kitchen cabinet door hung rack is square.


Final Thoughts

The project has no back to it.  Please don't go out and buy those 90 degree metal pieces to attach this to the inside of your kitchen cabinet.  Nothing says "cheap store bought" than those things.

I would use a keyhole bit in my router to route some keyholes that would seamlessly and securely hang this anywhere I wanted.

By the way, this would look great not only on the inside of your cabinet door but also any place on a wall that needs a little extra styling.

Obviously you would need to measure the distance between the inside of your cabinet door and the front of the shelves.

This particular project posting was measured to fit those 5.5oz bottles of spices.




Until then!


No comments:

Post a Comment

Comments are held for moderation before they are published. If you would like to be notified of responses please check the "notify me" box.