Sunday, April 30, 2017

DIY Cutting Board Storage Solution - Inside Cabinet Door Rack




The inside of kitchen cabinets can quickly become unorganized piles of messes where only the bravest dare tread.

Our cutting boards were at one time just pushed along the side of a cabinet propped up by a few pots or pans they shared the space with.  I'm sure you know the set up.  Perhaps you are there right now.

Whenever we would take out a pot the cutting boards would have to be propped up by a new pan.  Inevitably something wouldn't go right and I'd end up making a bunch of noise as things fell awkwardly.

Then I would just push and shove things in order to close the cabinet door and end the whole horrible ordeal.

Lets fix that, shall we!

DIY Cutting Board Storage Solution




Materials


1 - 1x4 (1/2" Thickness)

NOTE: All board lengths are 8' long and 3/4" thick unless otherwise noted.

Choice of Stain




Cut List

1 Bottom @ .5" x 3" x 14.5"
 
1 Bottom Front @ .5" x 1.5" x 14.5"
1 Top Front @ .5" x 1" x 14.5"
2 Back Verticals @ .5" x .5" x 8"
4 Sides @ .5" x 1" x 2.5"

Cutting Diagrams


1x4s



Step 1

This project is fairly safe to go ahead and cut all your pieces to length at the start.  Then glue and clamp two of the side pieces to the bottom piece.






Step 2

The two vertical back pieces can be glued in place after step one has had at least a half an hour to dry.



Step 3

After each of these steps you are going to want to wait about 30 minutes before continuing.  Why?  Because that is how long it takes most wood glues to set up.

This step is slightly different than what you see me doing in the video.  I lengthened these side pieces by half an inch so I could cut the notches for the vertical back pieces.  This gives me a little more gluing surface and makes the project a little stronger.

HOWEVER,  this is not necessary and the project is plenty strong after it is assembled without doing what I did.  If you just follow the steps listed here your project will be just fine.

How do I know?

Because I built one both ways and I see zero difference.




Step 4

Step four of is the final step in the assembly process of our new storage solution.  Simply glue and clamp the two front pieces in place.


Final Thoughts

Obviously the next step would be to drill two countersunk screw holes on each of the vertical back pieces.  Then simply attach the rack to the inside of your cabinet door.

Just make sure to choose a screw size that is long enough to secure the project to the door without falling off but not long enough to protrude through the front of your cabinet door.

Assuming most cabinet doors are 3/4" thick and the vertical pieces of the cabinet rack is 1/2" means a three quarter inch long screw should suffice.

Obviously as the disclaimer says below, check your situation and proceed at your own risk.  (Paraphrased obviously.)

Before you do the mounting work however, you will want to sand the whole project, round off any sharp edges and apply your choice of stain and sealant.


Until then!


0
http://www.simplyeasydiy.com/search/label/Beginners